Sorry, you need to enable JavaScript to visit this website.

can not program fpga

Zedboard forums is currently read-only while it under goes maintenance.

Unsolved
2 posts / 0 new
vasiana
Junior(0)
can not program fpga

I am using PicoZed 7030 SOM + FMC Carrier V1 board and I am trying the tutorials for the Picozed. I am currently in the second one and I am trying to program my board but the board doesn;t open as seen in pdf. The first set of leds are 3 red and 2 green on and SDK can't program fpga. I put the sw1 correct and i am using only one usb cable connected to usb - uart port. Any guests?
Thank you!

fletch
Moderator(23)
JTAG Cable

You program the Zynq with a USB-JTAG cable. I suggest the www.avnet.me/jtaghs3.

You can also program the Zynq from the SD Card. Skip ahead to Tutorial 4 to see instructions on how to do this.

Bryan